K Line Interface Schaltplan
K Line Interface Schaltplan. On port rc1 you can connect a led (optional). Low speed (125kb) can bus.
Posted in /dev/random on june 18, 2017 by connor. Vcds 15.7.1 is compatible with the following interfaces: Vcds 15.7.1 is compatible with the following operating systems:
I Heard A Bus Transceiver Ic, Mc33290.
Today, it is being replaced in new projects by can. Vcds 15.7.1 is compatible with the following interfaces: I will send the data using rs232 protocol and a convertor(k line to rs232) send the data via k line to other circuit which have k line transceiver to its microcontroller.
This Is Why It Was Stipulated In The First Obd Standards And Has Been In Use Ever Since.
New customer screening automated export system (aes) procedures Its either 12v dc when at rest or 0v dc when transmitting. Is this ic good for me?
Restbus Simulation And Test Of Complex Control Units.
November 27, 2007, 09:47:13 21:47. The “high” voltage level is actually the battery voltage (so it varies between 12v and 14,4v if the engine is running). The vehicle to the tester.
This Bus Used For Some Ic, Rfa And Other Units.
On port rc1 you can connect a led (optional). The vag kkl usb interface is a cost effective diagnostics and reprogramming tool compatible with the iso9141 and kwp2000 communication protocols found on many vehicles and motorcycles and is compatible with a wide range of 3rd party diagnostic software. The device’s k line bus driver’s output is fully protected.
C=100Nf (Smd1206), 4.7Uf /10V/, 10Uf /16V/.
Although it can address a large number of ecus on a bus, it was usually used for a single ecu or just a few ecus. Sat jan 31, 2009 3:19 pm. A scope is very helpful here.